Search Results for "from"

A Swagelok changeover (SCO) is a special type of primary gas control system, pre-engineered for applications where the continuous supply of gas is critical. Accomplished through staggered set points of two pressure regulators, the SCO will switch from a primary to a secondary source of gas when the ...

• ZH
• ES
• FR
• RU
• DE
• EN

SSI Systems are designed to handle incoming gases usually from a bottle or bottle multi pack source. The gas will flow thru the SSI and connect to one of the other Swagelok systems, typically a Swagelok Gas Panel (SGP), where the pressure can be regulated.

• ZH
• ES
• FR
• RU
• DE
• EN

While holding the fitting body steady, tighten the plug onequarter turn from the finger-tight position.

• RU
• JA
• EN

Remove snap ring from bottom of plug using snap ring pliers. Remove plug/handle subassembly by lifting straight up on handle.

accommodates both bare tubing and single-jacketed tubing; accommodates tubing sizes ranging from 1/8 to 1/2 in. and 3 to 12 mm; weighs approximately 16.3 lb (7.4 kg).

• JA
• EN

Remove and discard the old shoulder screws and spring washers from the bender die and roll support; Apply two drops of thread locking adhesive to the threads of each shoulder screw. Apply two drops of a light machine oil to the nonthreaded area of each shoulder screw.

• JA
• EN

This “60E” Series Ball Valve contains several component parts with materials different from those found in the standard “60T” Series Ball Valve.

• RU
• EN

Features: Remove plug at top of the handle, Loosen the screw and remove the handle, Multiposition handle - remove the positioner from the flanges by using a screwdriver as a lever.

• JA
• EN

Remove the inlet pressure to the solenoid; Disconnect the plug-in wire assembly and the tubing from the solenoid push‑to‑connect fitting (push the collar towards the fitting and pull the tubing).